How to write to NTFS disks with MacOS from scratch? step by step guide

The Mac OS NTFS file system is one of the most widely used file systems.through which you can organize the data on the hard drive or other storage units of your Mac, thus offer significant advantages compared to other file extensions.

Yes ok this type of disk is used in most computerssince Windows until Mac, the latter has a marked limitation, so users are only allowed to read, but not writeand this causes a considerable amount of trouble for OSX users.

In the next few paragraphs, we will teach you everything you need to know about NTFS disks in Mac OSfrom what it is and what it is used for, to the steps you can follow to write on this disc without the need for third-party applications.

What is an NTFS disk?

NTFS are the initials of New Technology File Systemor new technology file system, is a file system that is widely popular thanks to its use in the Windows operating system, that allows its users to organize the information stored on their hard drives or other storage media.

One of the main characteristics is the large volume of data that it allows to store. This is because the maximum size of a partition on an NTFS system is approximately 2 terabytes.presenting a noticeably larger space than other file systems such as FAT32.

In the NTFS system, the data of the files is registered in the MFT or master file table, which is a list that compiles the storage support information of each file, as well as the permissions of these:

Learn how to write to NTFS disks from Mac OS

Mac OS counts natively with a method to write to NTFS drivesalthough this process can be quite complicated, since it is done from the Finder application, and you must meet certain requirements. To begin with, the drive you want to write to must be formatted in NTFS and you must know its name in detail.

Once you meet these requirements, you must follow the steps described below:

• open terminal from your mac

• Enter the command “sudo nano/etc/fstab”

• In the text editor that will open, you must enter the command “LABEL=DISCONTFSnone ntfs rw,auto,nobrowse” making sure that the word “DISCONTFS” be replaced by the name of the unit

A) Yes, you will be able to close the editor and you will have the possibility to write and read on the NTFS drives connected to your Mac. It should be noted that these drives do not appear mounted in Finderbut you must find them in the terminal via command “open/Volumes”which will give you access to the NTFS disk that is connected.